Wayne Kerr 3260B Overview
3260B
Wayne Kerr Magnetic Analyzer
Features the most state-of-art magnetics analyzer with the highest accuracy rate in the market. Its design conforms to the measurement function of all coil product needs, either it is the sole inductance or the transformer, 3260B can satisfy your test demands. 3260B provides the frequency range from 20Hz to 3MHz, the telecom measurement functions, the graph scanning components characteristic, on the high speed production line tests, and may coordinate the high bias current test. Most important is it has precise accurate and the stable gauging performance.
- Wide frequency range of 20 Hz to 3MHz
- 0.1% basic accuracy
- Internal 1A DC bias current
- Up to 125A of DC bias current
- Bin Handler Mode (option) sort components in up to 10 bins
- Analysis mode - graph measured parameters against Frequency, AC Drive Level & DC Bias Current
- Z, L, C, Rac, Ø, Q, D, Rdc & Turns Ratio
- Straightforward intuitive operation
- Print test results
- IEEE 488 GPIB control with LabVIEW? driver
|
Technical Specifications: |
Measurement Function | L,Z,Rdc,C,Q,D,Rac,Angle | Frequency Range | 20 Hz to 3 MHz Option | Drive Level | 1 mV to 10 V rms into open curcuit 50 uA to 200 mA rms into short circuit | Internal DC Bias Supply | 1 mA to 1 A | Insulation (Option) | Test voltages 100 V, 200 V, or 500 V DC, user selectable | Measurement Speeds | 4 speeds selectable (20/sec max) | Measurement Ranges | R 0.01 mΩ to > 2 GΩ L 0.1 nH to >1000H C 5 fF to > 1 F | Accuracy | L/Rac/Z/Cp ±0.1% Q ±0.1% (Q+1/Q) D ±0.001 (1+ D2) Turns ratio ±0.1% Rdc ±0.5% |
|
General Data: |
Input Specification | Power supply 230 V AC ±10% or 115 V AC ±10% (selectable) 50 to 400 Hz 400VA maximum consumption | Display | High contrast monochrome LCD 320 x 240 dot with CFL back lighting Visible area 115 x 86mm Viewing angle 45° | Measurement Connections | 8 front panel BNC sockets 2- or 4-wire (Kelvin) measurements with screen at ground potential Equivalent circuit symbols on screen Separate terminals for primary and secondary connections. Leds indicate active terminals |
|