150A400 - AR Worldwide Amplifiers





Request a Quotation
















No Substitutes

Add me to your email list for monthly specials.
(private list no 3rd party use)
Technical Specifications

Frequency Range - High
400.00MHz

Output - Compression
125 W

Gain
52.0dB

Extra Specifications
Mid Power RF amplifier 150 Watt CW, 100 kHz-400 MHz


Product Description

The Model 150A400 amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. The Model 150A400, when used with an RF sweep generator, will provide a minimum of 150 watts of swept power. There is a digital display on the front panel to indicate the operate status and fault conditions when an over temperature, power supply, or amplifier fault has occurred. The unit can be returned to operate when the condition has been cleared. The 150A400 includes digital control for both local and remote control of the amplifier. This 8-bit RISC microprocessor controlled board provides both IEEE-488 (GPIB) and asynchronous, full duplex RS-232 control of all amplifier functions. All amplifier control functions and status indications are available remotely in GPIB / IEEE-488 format. The buss interface connector is located on the back panel and positive control of local or remote operation is assured by a keylock on the front panel of the amplifier. Housed in a stylish, contemporary enclosure, the Model 150A400 provides readily available RF power for typical applications such as RF susceptibility testing, antenna and component testing, watt meter calibration, and use as a driver for higher power amplifiers.