Com-Power CDN-M450E Coupling/Decoupling Network

$2,478.00





Request a Quotation
















No Substitutes

Add me to your email list for monthly specials.
(private list no 3rd party use)
Technical Specifications

150 MHz to 230 MHz

Meets CISPR 16-1-2 requirements

Extra Specifications
New, in box. MFR's 3 year warranty and individual calibration.


Product Description

Com-Power CDN-M450E

  • Frequency range: 150 MHz to 230 MHz
  • Meets CISPR 16-1-2 requirements
  • Up to 50 Amps AC current handling
  • Individual calibration
  • Three Year Warranty

 BRL Test is your authorized Com-Power distributer. 

Com-Power CDN-M450E is a part of the series of Coupling/Decoupling Networks designed specifically for testing product for conducted immunity per IEC/EN 61000-4-6. The CDN-M450E is designed for testing products that uses four conductor power cable. It has five 4 mm shrouded banana socket for both EUT and AE power connections. The CDN-M450E can handle up to 50 Amps AC and 35 Amps DC of current. The RF disturbance signal coupling port is female BNC. It can handle up to 40V of RF input Voltage. The bottom surface of the CDN is not painted for easy and effective grounding. All Com-Power CDNs are individually calibrated. The Com-Power CDN-M450E fully complies with the requirement contained in the IEC 61000-4-6 and CISPR 16-1-2. All Com-Power CDNs can be purchased separately or as part of the CIS series conducted immunity test system. This is a pre-packaged solution that includes an ACS series power amplifier and all accessories required for the test. Coupling Decoupling Network CDN-M450E 

 During conducted Immunity testing, CDNs are utilized to provide a means of coupling RF common mode signals to the power supply lines. In addition, CDNs provide required common mode impedance between the power supply lines and ground, minimize interference to the auxillary equipment via common mode decoupling of the disturbing signals and provide uninterrupted path for the power to the EUT. Before you begin testing with the CDN-M450E you will need to establish calibrated drive levels corresponding to your desired test levels. During drive level calibration, the RF signal level being injected to the CDN is adjusted incrementally until the voltage level measured at the 150Ω to 50Ω adapter (ADA-515-2) connected to the EUT port is approximately equal to the Umr value. CDNM450E