TTI -Thurlby Thandar Instruments PL320 Overview
The Thurlby Thandar PL series of laboratory bench power supplies has established itself in many countries as an “industry standard” range.
PL series units incorporate digital meters with a 3.75 digit scale length (4095 counts) to provide greater accuracy and resolution than other PSUs.
Large and bright LEDs give a clear and unambiguous reading. An update rate of 4 per second provides near instantaneous response.
Separate meters are used for voltage and current, eliminating the need for meter function switches with their attendant problems of misinterpretation.
A damping switch for the current meter simplifies measurements on rapidly varying loads.
Remote sense terminals enable the precision to be maintained at high currents by eliminating the effects of connection lead resistance.
Without remote sense lead resistance of just a few tens of milliohms can seriously degrade regulation and produce misleading results. (Two cables of 0.05W each will drop a total of 0.3V at 3 Amps.)
The PL series sets the standard for simple and comprehensive control. Voltages are set with coarse and fine controls for speed with precision. Currents are set with a semi-logarithmic control for increased resolution at low current levels.
The DC output switch enables voltage and current levels to be set before the load is connected. With the output switch “off” the the current limit set point is displayed. With the output switch “on” the actual output current flowing is displayed.
This invaluable feature allows delicate circuits to be protected by accurately setting the current limit level (down to a few milliamps if necessary) before connecting the circuit under test.
- 15V/4A, 32V/2A or 32V/3A; LED displays
- Wide model range, single, dual or triple outputs
- Separate digital meters for voltage and current
- Twin 3¾ digit meters with 12.5mm LEDs
- 0.1% accuracy, 10mV and 1mA resolution
- Parallel, series and tracking modes on duals/triples
- High current 5V logic output on triples