BRL Test, Inc.

Electronic Test Equipment

Below Budget - On Time - Above Expectations

Manufacturers

Testimonials

  • ★★★★★

    "Fantastic deal. The oscilloscope is in very good condition. Packed for shipment to survive anything"
    Jeff
  • ★★★★★

    "Premium equipment. Excellent communication. Fast. Best value!"
    Avi
  • ★★★★★

    "Practically in new condition"
    Darcy
  • ★★★★★

    "There was a small issue; The people at BRL Test were 100% responsive and issue resolved. Thanks!"
    Mike
  • ★★★★★

    "Best packing ever! I would let you ship one of my children!"
    Todd
  • ★★★★★

    "Unit received in great shape. Passed Agilent calibration. Good job!!"
    Lee
  • ★★★★★

    "In every aspect these guys are great!"
    Sarah

Join our Newsletter

See the Videos

LCA-30-1T - FEMTO Current Amplifiers


Get Quote

  • Model: LCA-30-1T
  • Manufactured by: FEMTO
  • Bandwidth: 30.00Hz
  • Gain [V/A]: 1x10^12
  • Input Noise: 0.5 fA/Hz^1/2
  • Extra Specifications: Ultra-Low-Noise Current Amplifier
Why Use a Preamplifier Module? Unlike desktop amplifiers, preamplifier modules provide gain close to the detector before the signal-to-noise ratio significantly decreases due to cable capacitance and noise pickup. Signal processing and measuring after pre-amplifying has no effect on the signal/noise performance. Gain and Noise In order to achieve an extremely low noise performance very high gains were chosen, while nevertheless minimizing the associated bandwidth reduction.Thus, as a result of our sophisticated development efforts we can offer a professional "High-End" Current Amplifier line. The noise performance of our products surpasses by far that of conventionally designed OpAmp current-to-voltage converters at the corresponding bandwidth. Bandwidth and Frequency Response FEMTO Current Amplifiers show almost ideal behavior without the need for special adaptations or frequency compensations. Bandwidth and frequency response are independent of source capacitance up to 10 nF. No gain peaking will occur. Preamplifier for Lock-Ins Lock-In-Amplifiers usually have a special current input. By using instead a low noise preamplifier in noise limited experiments even the sensitivity and speed of a DSP Lock-In is strongly increased. Femtoampere currents can then be measured within a few milliseconds. Applications Photodetection with PMTs and Photodiodes Spectroscopy Scanning Tunneling Microscopy Ionization Detectors Pyro- and Piezoelectric Detectors
Your IP Address is: 18.234.236.14