BRL TEST INC.

Electronic Test Equipment

Below Budget - On Time - Above Expectations
Search our test equipment


 

World Class Repair Lab

Our 67 ghz enabled lab performs free repair evaluations for your equipment.


 Learn More 

Timely Results

Fastest turn around in the industry.



 Learn More 

Manufacturers

Join our Newsletter

See the Videos

Touch 1 ULTRA - Cirris Hipots


Contact for Quote

  • Model: Touch 1 ULTRA
  • Manufactured by: Cirris
  • Max. Output AC Voltage: 2.000kV
  • Max. Output DC Voltage: 2.800kV
  • Output AC Current: 1.5mA
  • Output DC Current: 10.0mA
  • Extra Specifications: Signature Multi-point high voltage Cable/Harness and Connector Tester
  • Built in PC: The Touch 1 Ultra features an integrated PC, complete with floppy and hard disk drives; keyboard, monitor, serial and parallel ports and an optional ethernet port combined with an AR Hypot Ultra III to offer the lowest cost high voltage multi point tester available.
  • Rack Mounted: The Touch 1 Ultra comes in a 24 inch wide rack.
    Cirris HVI Interface: The Touch 1 Ultra features the Cirris HVI interface for ease of fixturing to your device under test.
  • Password Protection: Allows you to create custom access levels for each operator.
  • Graphical Touch Screen Display: The large graphical touch screen panel provides operator interface to the Touch 1. Simple to follow menus prompt the user through all of the setup functions. From resistance and voltage settings to point labeling and file naming, it is all at your fingertips.
  • Complete Testing: The Touch 1 performs the most thorough testing possible on your wiring assemblies. It checks for opens, shorts, mis-wires, high
    resistance connections (due to cold solder joints, mis-crimping, etc), and
    insulation problems such as leakage, dielectric failures, etc. It can also test
    resistors, diodes and capacitors.
  • 4-Wire Kelvin Test: When used in the 4-wire mode the Touch 1 nulls out fixture resistance and performs resistance measurements down to .001ohm resolution.
  • Automatically Calculates Resistance Values: If you are not sure what resistance value you should be testing to, the Touch 1 can help. Simply plug on a sample assembly and it will give you the actual measured resistance values and suggested settings. 
  • Which End Error Detection: The Touch 1 further simplifies your job by identifying which end of an assembly has an open or short.
Your IP Address is: 54.196.42.8