BRL Test, Inc.

Electronic Test Equipment

Below Budget - On Time - Above Expectations
Search our test equipment


World Class Repair Lab

Our 67 ghz enabled lab performs free repair evaluations for your equipment.

 Learn More 

Timely Results

Fastest turn around in the industry.

 Learn More 


Join our Newsletter

See the Videos

HT5000-200mA - Compliance West Hipots

Get Quote

  • Model: HT5000-200mA
  • Manufactured by: Compliance West
  • Max. Output AC Voltage: 5.000kV
  • Max. Output DC Voltage: 7.000kV
  • Output AC Current: 200.0mA
  • Output DC Current: 200.0mA
  • Extra Specifications: Special-Use Hipot Tester

Our HT5000-200mA has AC and DC output, each capable of 200mA output. Leakage current limits can be set with the rear panel knob from 10mA to 200mA. Normal operation stops testing when a leakage current greater than the set amount or when a dielectric breakdown is encountered. If desired, testing can be set to continue to burn problem areas. Testing will continue until the design current limit of the tester is exceeded; at which time the output voltage will return to zero.

In any device, lower ripple voltages require larger filter capacitors, which store more power, and that power is normally used to smooth the rectified waveform. In the case of a hipot tester, this stored power has the side effect of discharging into the EUT in the event of a failure. In order to keep the power that must be absorbed by the EUT within reasonable limits, we have used three phase input power for this model, which improves ripple without the side effect of excessive power sent to the EUT when a dielectric breakdown is detected.

Packaged in a 6U enclosure, with all controls and switches on the front panel for easier access. Provided with test leads terminated in alligator clips and a calibration certificate; one year warranty on parts and labor.

Your IP Address is: