SMATE200A - Rohde & Schwarz Signal Generators

Rohde & Schwarz SMATE200A Overview

The R&S SMATE200A is based on the successful R&S SMU200A but is specifically designed to meet production requirements. It comes without a display or keys on the front panel, and its connectors are located at the rear. In addition, it is optimized for faster setting times in order to reduce test time.

• Very short setting times for frequency and level (<3 ms) In List mode, setting time reduced down to <400 µs through use of predefined frequency and level values
• Flexibly addressable Fast Hop mode with setting times same as in List mode
• Multisegment waveform function enables fast switching between different test signals in baseband
• Electronic attenuator for entire frequency and level range
• Status LEDs on front, connectors on rearÜ
• Very low SSB phase noise of typ. 135 dBc, or typ. 140 dBc with the Low Phase Noise option (20 kHz carrier offset, f = 1 GHz, 1 Hz measurement bandwidth)
• Wideband noise of typ. 153 dBc (>5 MHz carrier offset, f = 1 GHz, 1 Hz measurement bandwidth)
• High output power of typ. +26 dBm with High-Power Output option
• Very high level repeatability of typ. 0.05 dB
• I/Q modulator with 200 MHz system bandwidth
• Excellent ACLR performance of typ. +70 dB with 3GPP FDDÜ
• Up to two complete independent signal generators in one unit
• Choice of 3 GHz and 6 GHz frequency options in both paths
• Up to two independent baseband sources that not only support realtime signal generation but also offer arbitrary waveform generation with up to 64 Msamples eachÜ
• Digital Standard Eutra/LTE available
• Remote-controllable via LAN (Gigabit Ethernet) and GPIB