BRL Test, Inc.

Electronic Test Equipment

Below Budget - On Time - Above Expectations

Manufacturers

Testimonials

  • ★★★★★

    "Fantastic deal. The oscilloscope is in very good condition. Packed for shipment to survive anything"
    Jeff
  • ★★★★★

    "Premium equipment. Excellent communication. Fast. Best value!"
    Avi
  • ★★★★★

    "Practically in new condition"
    Darcy
  • ★★★★★

    "There was a small issue; The people at BRL Test were 100% responsive and issue resolved. Thanks!"
    Mike
  • ★★★★★

    "Best packing ever! I would let you ship one of my children!"
    Todd
  • ★★★★★

    "Unit received in great shape. Passed Agilent calibration. Good job!!"
    Lee
  • ★★★★★

    "In every aspect these guys are great!"
    Sarah

Join our Newsletter

See the Videos

LIT-930A - Com-Power Transient Limiters

$350.00

 

Com-Power LIT-930A

Conducted EMI emissions measurement are conducted using Line Impedance Stablization Network (LISN). The EMC receiver input is connected live and neutral line of the product via the LISN. The LISN blocks the supply voltage from LISN RF portt but allow the RF signal to pass without much attenuation, so that it can be measured with a EMC receiver. Because the RF signal must be passed through, any short transients (a few microseconds or less) on the power supply lines will also be passed through. Trasient limiter LIT-930A protects the EMI receiver input from these short transients A transient with high enough energy witll damage a unprotected receiver input.

The LIT-930A features a broader frequency range than the LIT-153A, in that the low end of the its operation extends down to 9 kHz. The unit also features higher maximum input level ratings, as it can withstand input levels up to 4 watts CW (+36 dBm), +/- 15 Vdc. Its VSWR is less than 1.1:1.

Other than these differences, you connect and use the LIT930A spectrum analyzer transient limiter in the same manner as the LIT-153A.
Your IP Address is: 54.167.47.248