BRL Test, Inc.

Electronic Test Equipment

Below Budget - On Time - Above Expectations

Manufacturers

Testimonials

  • ★★★★★

    "Fantastic deal. The oscilloscope is in very good condition. Packed for shipment to survive anything"
    Jeff
  • ★★★★★

    "Premium equipment. Excellent communication. Fast. Best value!"
    Avi
  • ★★★★★

    "Practically in new condition"
    Darcy
  • ★★★★★

    "There was a small issue; The people at BRL Test were 100% responsive and issue resolved. Thanks!"
    Mike
  • ★★★★★

    "Best packing ever! I would let you ship one of my children!"
    Todd
  • ★★★★★

    "Unit received in great shape. Passed Agilent calibration. Good job!!"
    Lee
  • ★★★★★

    "In every aspect these guys are great!"
    Sarah

Join our Newsletter

See the Videos

9250 - Tabor Electronics Amplifiers


Get Quote

  • Model: 9250
  • Manufactured by: Tabor Electronics
  • Frequency Range - High: 15.00MHz
  • Output - Compression: n/a
  • Gain: n/a
  • Extra Specifications: Differential / Dual-Channel Wideband Amplifier

The 9250 is a bench-top, 2U, half 19” rack size, fully metal case dual channel amplifier. The instrument can be configured to be used as two, single-ended independent channels, or as a one input with two differential outputs.

The inputs to the amplifiers be configured to match different source impedances such as 50W, 75W, or 1MW and the outputs can be configured to match different load impedances such as 50W, 75W, or 600W. There are three inputs for each channel.

The outputs are located on the front panel. There are two outputs, one for each channel. When the 9250 is configured as two separate amplifiers, the outputs generate amplified signals within the range of 40Vp-p into open circuit or 20Vp-p into matching load impedance. The bandwidth of the outputs is around 20MHz for large signals. Small signal bandwidth can reach 50MHz.

The 9250 can be configured as a differential amplifier. In this case, the channel 2 input is disabled and channel 1 input is amplified and distributed differentially to both outputs. In this case, channel 1 output generates in-phase signal while channel 2 outputs an inverted signal that has exactly 180 phase offset to the normal output. Full amplitude and bandwidth is preserved when the 9250 operates in differential mode. The output impedance of the differential outputs is modified to 25W, 37.5W, or 300W for differential drive of 50W, 75W, or 600W loads. Using the differential mode, the 9250 does not sacrifice accuracy, nor does it sacrifice bandwidth.

The 9250 has two additional inputs for each channel allowing summation of two signals and providing an external control of DC level offset. These inputs are accessible from the rear panel only.

  • Large signal bandwidth to 15 MHz
  • Small signal bandwidth to 30 MHz
  • High amplitude to 40Vp-p (into high impedance)
  • Slew rate to 200V/µs
  • Low distortion
  • Custom Configuration of: Gain, Input impedance, Output impedance, Output configuration
Your IP Address is: 34.229.126.29