BRL Test, Inc.

Electronic Test Equipment

Below Budget - On Time - Above Expectations



  • ★★★★★

    "Fantastic deal. The oscilloscope is in very good condition. Packed for shipment to survive anything"
  • ★★★★★

    "Premium equipment. Excellent communication. Fast. Best value!"
  • ★★★★★

    "Practically in new condition"
  • ★★★★★

    "There was a small issue; The people at BRL Test were 100% responsive and issue resolved. Thanks!"
  • ★★★★★

    "Best packing ever! I would let you ship one of my children!"
  • ★★★★★

    "Unit received in great shape. Passed Agilent calibration. Good job!!"
  • ★★★★★

    "In every aspect these guys are great!"

Join our Newsletter

See the Videos

6610 - Krohn-Hite Phase Meters

Get Quote

  • Model: 6610
  • Manufactured by: Krohn-Hite
  • High end frequency limit: 10MHz
  • Accuracy: 0.02_
  • Resolution: 0.01_
  • Extra Specifications: Precision Phasemeter
The Model 6610 provides precision phase measurements with a typical accuracy of 0.02° and 0.01° resolution over most of the frequency range. It will accept a wide range of input signal levels from 10mV to 320V rms and input waveforms including sine, triangle, square and pulses. A 5 digit, LED display provides continuous direct readout of phase angles between 0.00° and 360.00° or ±180.00°. These two ranges can be manually or automatically selected. Two common factors will affect the accuracy of a phasemeter are distortion and/or broadband noise present on either or both the input signals. A unique circuit design used in the 6610 significantly reduces any effects that may be caused by these two factors. Another problem found in most phasemeters is the inability to respond to very small phase angles, resulting in fluctuations or inconsistencies in the meter reading (sometimes referred to as ambiguity). To overcome this problem, the 6610 uses a design that eliminates any ambiguities that may occur at readings near 0°, 180° and 360°, and allows measurements as small as 0.01° to be made. The 6610 provides a RELATIVE measurement mode which allows the monitoring of phase deviations without having to make unwanted calculations. Also provided are an automatic selection of the input voltage range, front panel indictors to indicate a too low/high input voltage range, and an analog output for use with an external meter or strip chart recorder. Part no. RK-316 permits the installation of the Model 6610 into a standard 19" rack spacing.
Your IP Address is: