BRL Test, Inc.

Electronic Test Equipment

Below Budget - On Time - Above Expectations
Search our test equipment


 

World Class Repair Lab

Our 67 ghz enabled lab performs free repair evaluations for your equipment.


 Learn More 

Timely Results

Fastest turn around in the industry.



 Learn More 

Manufacturers

Join our Newsletter

See the Videos

J2100A - Picotest

$525.00

  • Model: J2100A
  • Units in Stock: 1
  • Manufactured by: Picotest
  • Extra Specifications:
    • 1Hz supports PFC regulators
    • 5MHz high enough for most power supplies and regulators
    • 23 Octave range
    • Low distortion for superior precision
    • 5 Ohm termination for minimum impact to loop
    • Includes attenuation to assure small signal measurement
 
The injection transformer is for connecting the network analyzer to the circuit being tested, and is used for control loop stability measurements. The transformer can inject a signal into the control loop being measured, without impacting the performance of the loop. The transformer is isolated and therefore is capable of floating on a high voltage, such as a Power Factor Corrector (PFC), which is often close to 400VDC. Measuring voltages that exceed the voltage rating of the Bode-100 inputs require attenuation probes.

The usable bandwidth of an injection transformer is generally significantly greater than the 3dB frequency limits. This is because the transformer itself is outside of the measurement, leading many to incorrectly believe that the transformer is a non-critical element.

The bandwidth of the transformer is strongly related to the terminating impedance. The Bode-100, and most network analyzers, provide a 50 Ohm oscillator source impedance. Assuming this impedance the optimal termination resistor is 5 Ohms. This significantly attenuates the injection signal, which is generally beneficial, as a common error in Bode measurements is using a signal which is too large, and therefore not a small signal measurement. An added benefit of this low value is that it can generally be left in circuit at all times, simplifying the connection to the network analyzer without appreciably impacting the output voltage of the circuit being tested.

Also see:
Your IP Address is: 54.198.55.167