BRL TEST INC.

Electronic Test Equipment

Below Budget - On Time - Above Expectations
Search our test equipment


 

World Class Repair Lab

Our 67 ghz enabled lab performs free repair evaluations for your equipment.


 Learn More 

Timely Results

Fastest turn around in the industry.



 Learn More 

Manufacturers

Join our Newsletter

See the Videos

PAL-010 - Com-Power Preamplifiers


Contact for Quote

Com-Power PAL-010

BRL Test is your authorized Com-Power distributer 407-682-4228.
 
The PAL-010 is primarily used for EMC radiated emissions testing. These preamplifiers can be used during EMC testing for FCC, CISPR, EN, FAA and MIL-STD. This preamplifi er could also be used in other applications that require a high gain preamplifier.
The enhanced system sensitivity due to high gain is very helpful when making EMC measurements using antennas on an Open Area Test Site (OATS) or probing a printed circuit board using Near Field Probes. This allows measurements of those frequencies from the equipment under test, that are not visible on the spectrum analyzer display unless amplifi ed. The preamplifi er gain will cause peaks to be visible above the background noise of the analyzer. These frequencies may go undetected if a preamplifi er with a high gain was not used.
In addition, preamplifiers could improve sensitivity of counters and power meters. The PAL-010 can also be used to increase the available power from your sweeper or signal generator. FeaturesThe PAL-010 is primarily used for EMC radiated emissions testing. These preamplifi ers can be used during EMC testing for FCC, CISPR, EN, FAA and MIL-STD. This preamplifier could also be used in other applications that require a high gain preamplifier. The enhanced system sensitivity due to high gain is very helpful when making EMC measurements using antennas on an Open Area Test Site (OATS) or probing a printed circuit board using Near Field Probes. This allows measurements of those frequencies from the equipment under test, that are not visible on the spectrum analyzer display unless amplifi ed. The preamplifier gain will cause peaks to be visible above the background noise of the analyzer. These frequencies may go undetected if a preamplifier with a high gain was not used. In addition, preamplifi ers could improve sensitivity of counters and power meters. The PAL-010 can also be used to increase the available power from your sweeper or signal generator.
Features
Broadband - 100 Hz - 30 MHz
High Gain: 28 dB
Flat Response: ± 2 dB
Individual Calibration
Three Year Warranty
 
Your IP Address is: 54.92.164.184