BRL TEST INC.

Electronic Test Equipment

Below Budget - On Time - Above Expectations
Search our test equipment


 

World Class Repair Lab

Our 67 ghz enabled lab performs free repair evaluations for your equipment.


 Learn More 

Timely Results

Fastest turn around in the industry.



 Learn More 

Manufacturers

Join our Newsletter

See the Videos

PS-400 - Com-Power Near Field Probes


Contact for Quote

The PS-400 Near Field Probe Set is designed to assist in troubleshooting EMI problems both at the board level and at the component level. It is used to detect radiation from cables, cases, traces and ICs. Typically the broadband probe is used to locate the general area of emission. Then the tip probe is used to isolate the source to a specific trace or pin. Further analysis can be done by following the noisy trace to find the cause of emissions such as a broken transmission line or impedance mismatch. A typical use for the H-field probe is to verify the integrity of the chassis of your computer. This is done by moving the probe along the seams of the chassis which may be acting as slot antennas. This probe is also very useful for detecting magnetic noise sources such as large current switching circuits or transformers. By utilizing these probes, potential certification problems can be discovered and addressed before expensive compliance testing is done. This saves both money and valuable time. The net result is a reduction in testing costs and a decreased time to market.
Your IP Address is: 54.198.96.198