BRL Test, Inc.

Electronic Test Equipment

Below Budget - On Time - Above Expectations

Manufacturers

Testimonials

  • ★★★★★

    "Fantastic deal. The oscilloscope is in very good condition. Packed for shipment to survive anything"
    Jeff
  • ★★★★★

    "Premium equipment. Excellent communication. Fast. Best value!"
    Avi
  • ★★★★★

    "Practically in new condition"
    Darcy
  • ★★★★★

    "There was a small issue; The people at BRL Test were 100% responsive and issue resolved. Thanks!"
    Mike
  • ★★★★★

    "Best packing ever! I would let you ship one of my children!"
    Todd
  • ★★★★★

    "Unit received in great shape. Passed Agilent calibration. Good job!!"
    Lee
  • ★★★★★

    "In every aspect these guys are great!"
    Sarah

Join our Newsletter

See the Videos

LIN-115A - Com-Power Line Impedance Stblzr

$1,375.00

 

LI-115A

(discontinued)

Com-Power Line Impedance Stabilization Network LISN

Frequency range of 150 kHz to 30 MHz.
Fully compliant with CISPR 16-1-2 / ANSI C63.4.
?Air-core? inductors to prevent saturation.
Built-in Transient Limiter.
Individual Calibration Included.
Three-Year Warranty.
The LIN-115A Line Impedance Stabilization Network (LISN) provides the necessary measurement platform for performing power line conducted emissions compliance testing as required by most worldwide standards for commercial products. The LIN-115A is compliant with both CISPR 16-1-2 and ANSI C63.4. The LISN provides defined stable impedance and isolates the EUT from power source influences, thereby providing accurate and repeatable results. The LIN-115A includes one pair of single-conductor networks, housed together, to be installed in series with each current-carrying conductor in a single-phase, dual-phase or DC power system. A second LIN-115A pair can be used to accommodate 3-phase power systems (Wye or Delta configurations). The LIN-115A is equipped with IEC connector at the mains (power input) and NEMA 5-15R at EUT (power output) ports. This LISN uses air-core inductors to prevent saturation and permeability variation. The mounting plate of the LIN-115A is left unpainted in order to facilitate connection to earth ground in its installation, which is essential due to high leakage current. The LIN-115A has a built in transient limiter for impedance matching, reduction of out-of-band emissions and transient protection for your measurement instrument. All Com-Power LISNs are individually calibrated in compliance with the relevant requirements of CISPR 16-1-2 and ANSI C63.4. Impedance, Phase, Isolation, and Insertion Loss data is supplied with each unit, along with the calibration certificate. (also LI115A or LI 115A)
Your IP Address is: 107.23.37.199