BRL Test, Inc.

Electronic Test Equipment

Below Budget - On Time - Above Expectations

Manufacturers

Testimonials

  • ★★★★★

    "Fantastic deal. The oscilloscope is in very good condition. Packed for shipment to survive anything"
    Jeff
  • ★★★★★

    "Premium equipment. Excellent communication. Fast. Best value!"
    Avi
  • ★★★★★

    "Practically in new condition"
    Darcy
  • ★★★★★

    "There was a small issue; The people at BRL Test were 100% responsive and issue resolved. Thanks!"
    Mike
  • ★★★★★

    "Best packing ever! I would let you ship one of my children!"
    Todd
  • ★★★★★

    "Unit received in great shape. Passed Agilent calibration. Good job!!"
    Lee
  • ★★★★★

    "In every aspect these guys are great!"
    Sarah

Join our Newsletter

See the Videos

CLA-050 - Com-Power Absorbing Clamps


Get Quote

Com-Power CLA-050

BRL Test is your authorized Com-Power distributor

The CLA-050 and CL-150 absorbing clamps meet the CISPR 14 (EN 55014) section 6.11 requirement for measuring radio frequency power generated and fed to the EUT supply cable of household appliances, electrical tools and similar apparatus. The absorbing clamp consists of a calibrated ferrite current transformer operating in the frequency range of 30-1000 MHz and two groups of ferrite rings. The ferrite rings acts as absorbers of energy and stabilizes impedance. One set of ferrite rings surrounds the lead from the transformer to the EMI meter to minimize standing waves. The second group of ferrite rings surround supply cable from the equipment under test. These rings act as an absorber of energy and an impedance stabilizer to isolate the equipment under test from the mains. These rings are made up of two halves. Therefore, the supply cable from the EUT can be placed inside the aperture of the rings. Two absorbing clamp models are available to accommodate the varying sizes of supply cables. The model CLA-050 can accommodate supply cable up to 10 mm (0.39 inches) in diameter and model CLA-150 can accept cables up to 32 mm (1.26 inches) diameter. All absorbing clamps are individually calibrated before shipment. The insertion loss and correction factors will be supplied with each clamp.Use of an absorbing clamp is a practical alternative to measurement of direct field strength from EUT supply cables. During the test, the equipment under test is placed on a nonconductive table at least 40 cm from the nearest reflecting object. The EUT mains conductor is placed horizontally in a straight line for a distance sufficient to permit movement of the absorbing clamp to obtain the highest readings. The mains conductor is placed in the clamp surrounded by absorbing rings and the current transformer.
Your IP Address is: 54.91.121.255